The inverter has disconnected from the utility grid. If the grid operator gives his approval, discuss any changes to the operating parameters with the Service. If fluctuations occur frequently and this message is displayed often, contact the grid operator and request approval to change the operating parameters of the inverter. If possible, check the grid voltage and observe how often fluctuations occur. The inverter has reduced its power due to a too-high grid voltage to ensure grid stability. The inverter disconnects from the utility grid to maintain power quality.ĭuring the feed-in operation, check whether the grid voltage at the connection point of the inverter is permanently in the permissible range. The grid voltage or grid impedance at the connection point is too high. The ten-minute average value of the grid voltage is no longer within the permissible range. The inverter has disconnected from the utility grid.Įnsure that the miniature circuit breaker is switched on.Įnsure that the AC cable is not damaged and that it is connected correctly.Įnsure that the country data set has been configured correctly. The utility grid has been disconnected, the AC cable is damaged or the grid voltage at the connection point of the inverter is too low. If the grid voltage is permanently within the permissible range and this message is still displayed, contact the Service. The grid operator must agree with an adjustment of the voltage at the feed-in point or with a change of the monitored operating limits. If the grid voltage is outside the permissible range due to local grid conditions, contact the grid operator. The inverter has disconnected from the utility grid.Įnsure that the correct country data set has been configured.Ĭheck whether the grid voltage at the connection point of the inverter is permanently in the permissible range.
Worst case scenerio is that you or someone else renamed the image file to "rtr/.bin" while it was on the tftp server and somehow managed to get that on the router as such, and now the router is looking for a "rtr" directory on itself.The grid voltage or grid impedance at the connection point of the inverter is too high. Try making the destination filename ".bin" instead of "rtr/.bin" and see what happens.ĭestination file name ?.bin I suspect what is happening is that when you are trying to copy "rtr/.bin" over to the server, it is looking for a "rtr" directory on the server and rtr does not exist. considering that you were able to coy the running config to the tftp server already then you must have "write" permissions to the tftp default directory root. No you cannot rename the flash on the router (as far as i know) but you can rename it when it is destined for the tftpd server.
#Error an error type of 103 using tftp client code#
Jeff RE: TFTP: error code 0 received - TFTP Error: Path not found jamin123 (IS/IT-Management) 15 Jun 03 19:50 What could cause this? Here is some more information.ġ6384K bytes of processor board System flash (Read ONLY)Įxecuting current image from System flash TFTP: error code 0 received - TFTP Error: Path not found
OKĬopy 'rtr/.bin' from Flash to serverĪs 'rtr/.bin'? y Verifying checksum for 'rtr/.bin' (file # 1). Source file name? rtr/.binĭestination file name ? I am able to copy flash from a 2505 to my tftp server, and I can copy the running-config fine from the 2501 to the same tftp server, but when I try to copy the flash, this is what I get:Īddress or name of remote host ? 192.168.1.100
0 kommentar(er)
